HELP !!!!!!!!!!! Hopefully someone out there can help me with this information. I'm trying to make a block for checking the motor mounts on Panhead frames. The information I need is the exact height difference between the front and rear motor mount, the mounting bolt spacing (center to center) right to left, and the mounting bolt spacing (center to center) front to rear.
I have seen the blueprints shown on this forum and cannot make out the numbers. I have tried measuring the cases but the holes are to worn to be accurate. As I stated at the start HELP!!!!!!!!!!!!!!
Also, does anyone know where I can buy blueprints for frames or engines ?
Thank you
Motor mount information
Forum rules
Please do not start new topics here, but here: New Panhead and Flathead topics
Please do not start new topics here, but here: New Panhead and Flathead topics
-
- Inactive member
- Member
- Posts: 12
- Joined: Fri Jul 23, 2010 3:43 pm
- Bikes: 1946 U, Police bike
1960 Hardtail Bobber - Location: Hartland, WI.
-
- Moderator
- Senior Member
- Posts: 8414
- Joined: Sat Nov 15, 2008 4:09 am
- Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...
- Has thanked: 484 times
- Been thanked: 2958 times
Re: Motor mount information
All that information is in the '59-'69 factory service manual. All Pan and Shovel frame motor mount info is the same, regardless of frame type, rigid, or swing arm.
Those manuals are common, you should have one!
Robbie
Those manuals are common, you should have one!
Robbie
-
- Inactive member
- Member
- Posts: 12
- Joined: Fri Jul 23, 2010 3:43 pm
- Bikes: 1946 U, Police bike
1960 Hardtail Bobber - Location: Hartland, WI.
Re: Motor mount information
Thank you
I checked the manual, it gives height, and lenght, buy sais nothing about width. Were do I go from here?
I checked the manual, it gives height, and lenght, buy sais nothing about width. Were do I go from here?
-
- Moderator
- Senior Member
- Posts: 8414
- Joined: Sat Nov 15, 2008 4:09 am
- Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...
- Has thanked: 484 times
- Been thanked: 2958 times
Re: Motor mount information
My factory manual shows center to center, height and length. What manual are you looking at?
Robbie
Robbie
-
- Inactive member
- Member
- Posts: 12
- Joined: Fri Jul 23, 2010 3:43 pm
- Bikes: 1946 U, Police bike
1960 Hardtail Bobber - Location: Hartland, WI.
Re: Motor mount information
Robbie
My manuals show front to back, and height. Please let me know what the side to side messurement is.
Thank you
My manuals show front to back, and height. Please let me know what the side to side messurement is.
Thank you
-
- Inactive member
- Member
- Posts: 112
- Joined: Mon Jul 19, 2010 2:36 pm
- Bikes: 58FL
99M2Buell
89Sporty - Location: Sanford,mi.
- Been thanked: 1 time
Re: Motor mount information
ive run my pan for forty years, only recently did i discover that at the factory it appears they used shims under the bolt location to set the motors in the frames. no shims under mine guess im lucky. saw these shims in a catalog.