gasoline shut off valve
Forum rules
Please start new topics here: New Panhead and Flathead topics
Please start new topics here: New Panhead and Flathead topics
-
- Member
- Posts: 24
- Joined: Mon Sep 07, 2009 8:27 pm
- Bikes: 1962 FLH / 1972 FLH
- Location: N/W Indiana
gasoline shut off valve
I have acquired a set of 1962 gas tanks. It seems I need to chase and clean up the threads for the "Instant Reserve" fuel valve seat where it threads into the bottom of the left tank. Does anybody know what thread size this hole in the tank is and where I could find that size tap or thread chaser?
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: gasoline shut off valve
Zoomin!
The size is 3/4"-20, which is a special thread.
MSC Industrial has taps for about $23.
....Cotten
The size is 3/4"-20, which is a special thread.
MSC Industrial has taps for about $23.
....Cotten
-
- Member
- Posts: 24
- Joined: Mon Sep 07, 2009 8:27 pm
- Bikes: 1962 FLH / 1972 FLH
- Location: N/W Indiana
Re: gasoline shut off valve
Thank you sir, your knowledge and time taken to respond is much appreciated!
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: gasoline shut off valve
Correction!
I was wrong again.
It is 3/4"-18.
(I had it confused with the carb bowlstem threads which is also a special thread.)
Sorry.
...Cotten
(Zoomin! If you ordered a 3/4"-20 tap, I can always use another one.. PM me....)
I was wrong again.
It is 3/4"-18.
(I had it confused with the carb bowlstem threads which is also a special thread.)
Sorry.
...Cotten
(Zoomin! If you ordered a 3/4"-20 tap, I can always use another one.. PM me....)
-
- Member
- Posts: 24
- Joined: Mon Sep 07, 2009 8:27 pm
- Bikes: 1962 FLH / 1972 FLH
- Location: N/W Indiana
Re: gasoline shut off valve
Cotten, I didnt order the tap yet. Thanks for the correction. You had me sold, 3/4-20 sure looked like it would be the right size to me. Those are some really fine threads inside that bung.Cotten wrote:Correction!
I was wrong again.
It is 3/4"-18.
(I had it confused with the carb bowlstem threads which is also a special thread.)
Sorry.
...Cotten
(Zoomin! If you ordered a 3/4"-20 tap, I can always use another one.. PM me....)