I've decided to take the heads and possibly barrels of my FL '56 Panhead. Is this possible without removing the engine from the frame?
Thanks.
Remove heads - with engine still in frame?
-
- Inactive member
- Member
- Posts: 18
- Joined: Thu Jul 22, 2010 8:01 am
- Bikes: FL '56
XLH '65 - Location: Copenhagen
-
- Senior Member
- Posts: 2096
- Joined: Fri May 24, 2002 1:00 am
- Bikes: 64FL 99FLHR 01FXSTD
- Location: Mpls. MN.
- Has thanked: 71 times
- Been thanked: 149 times
Re: Remove heads - with engine still in frame?
You will only have to lift them about 1/8" off the cylinder to clear the fire ring...Mike
-
- Inactive member
- Member
- Posts: 18
- Joined: Thu Jul 22, 2010 8:01 am
- Bikes: FL '56
XLH '65 - Location: Copenhagen
Re: Remove heads - with engine still in frame?
But how about the rockerbox covers?
They seems to be awful close to backbone? 10mm. or so.
They seems to be awful close to backbone? 10mm. or so.
-
- Inactive member
- Member
- Posts: 292
- Joined: Sun Jul 25, 2010 5:18 pm
- Bikes: '50 F model, '76FX/L, '96 96" FXDWG
- Location: SE Florida
- Has thanked: 8 times
- Been thanked: 7 times
- Contact:
Re: Remove heads - with engine still in frame?
The rocker box covers come off with the heads.
If your engine hasn't been apart for a while, I would suggest inverting the head/rocker box assembly, after removal, and saturating the bottom of the rocker box screws with Kroil or similar, let it soak an hour, before attempting to remove the screws. This will reduce the chance of breaking a screw in the head.
If your engine hasn't been apart for a while, I would suggest inverting the head/rocker box assembly, after removal, and saturating the bottom of the rocker box screws with Kroil or similar, let it soak an hour, before attempting to remove the screws. This will reduce the chance of breaking a screw in the head.
-
- Inactive member
- Member
- Posts: 112
- Joined: Mon Jul 19, 2010 2:36 pm
- Bikes: 58FL
99M2Buell
89Sporty - Location: Sanford,mi.
- Been thanked: 1 time
Re: Remove heads - with engine still in frame?
i wasnt able to remove front rocker box with engine in frame,tried recently because gasket was leaking, ended up dabbing 3 bond on gasket and putting back together still leaks a little but way less.