Gas tank emblems
Gas tank emblems
I picked up a set of 64 OEM tanks and a set of OEM 63-65 emblems....I am alittle disappointed by the way they fit. The holes line up dead nuts but the contour is off....I worked them around the tank for a better fit but they are still alittle gappy on the bottom. Is there suppose to be a gasket between the tank and the emblem? I find it hard to believe that the Motor Company would have intended these to be mounted metal to metal.....Is this a common problem? I think I will make a set out of black rubber.
-
- Moderator
- Senior Member
- Posts: 8413
- Joined: Sat Nov 15, 2008 4:09 am
- Bikes: Multiple H-D, Ducati, BMW, Triumph, BSA,...
- Has thanked: 483 times
- Been thanked: 2958 times
Re: Gas tank emblems
Mark,
No gaskets is the correct assembly technique. And the emblems as sold by H-D (I have some NOS ones) are flat and have to be contoured to fit. Take your time and be patient and they will lay right on there.
Robbie
No gaskets is the correct assembly technique. And the emblems as sold by H-D (I have some NOS ones) are flat and have to be contoured to fit. Take your time and be patient and they will lay right on there.
Robbie