Perhaps you are too.
I have one screw for the tank badges and underline for a 53 panhead.
D=.112 L=.204, so #4 3/16"
Mcmaster has #4-40 and #4-48, which is it?
If anyone can answer I am impressed!
Jerry
I'm missing a few screws ...
-
- Senior Member
- Posts: 2405
- Joined: Wed Jul 07, 2010 4:28 am
- Bikes: 1950Panhead
- Location: USA
- Has thanked: 1 time
- Been thanked: 366 times
-
- Senior Member
- Posts: 2682
- Joined: Sat May 29, 2004 8:21 am
- Bikes: '31 VL, '34 VD, '45 WLA, '47 WL, '49 FL, '51 WL, '58 ST (Hummer), '71 GE (Servi)
- Location: Lonoke, Arkansas
- Has thanked: 5 times
- Been thanked: 49 times
Re: I'm missing a few screws ...
Jerry,
the screw is a 4-40 N.C. x 3/16, H-D part # 2060
don't get it confused with the SPECIAL screw which held the tank badges on '47-'50 tanks, that screw had its own part number, 61790-47, which is obviously not one of the generic hardware items which all had only 4 digit part numbers.
The Old Dude should have those.
mike
the screw is a 4-40 N.C. x 3/16, H-D part # 2060
don't get it confused with the SPECIAL screw which held the tank badges on '47-'50 tanks, that screw had its own part number, 61790-47, which is obviously not one of the generic hardware items which all had only 4 digit part numbers.
The Old Dude should have those.
mike
-
- Senior Member
- Posts: 2405
- Joined: Wed Jul 07, 2010 4:28 am
- Bikes: 1950Panhead
- Location: USA
- Has thanked: 1 time
- Been thanked: 366 times