Front fender
-
- Member
- Posts: 256
- Joined: Mon Apr 09, 2012 7:38 pm
- Bikes: '02 Fatboy, '47 Knuckle, '52Pan
- Has thanked: 60 times
- Been thanked: 11 times
Front fender
Anyone know what year fender has this hole pattern for the front trim, I was told it came off a '57 pan, I bought a fender tip for it and the pattern isn't even close, it's hard to find pictures up close of old sheet metal, any imfo would be appreciated, Thanks Whitey
You do not have the required permissions to view the files attached to this post.
-
- Former member
- Senior Member
- Posts: 3336
- Joined: Sat Jun 26, 2010 1:54 pm
- Bikes: 1958flh 1969sporty,had a knuckle but sold back to original owner
- Location: NEW JERSEY
- Has thanked: 195 times
- Been thanked: 278 times
Re: Front fender
Whity---I just looked at my old trim & it is 2 holes over each other., Im gonna take a shot & say--Are you sure about the year? The last bike I nstalled a fender with the upper 3rd hole, the hole was to hold a grommlet for a wire to a running light!, on the bottom rear of the fender do the holes line-up for the ribbed cover that wraps around & do the side trim pieces line-up also?----Richie
-
- Member
- Posts: 301
- Joined: Mon Jul 09, 2012 11:08 pm
- Bikes: 65FL and 2003 heritage
- Location: Southern Maryland
- Has thanked: 90 times
- Been thanked: 41 times
Re: Front fender
I have a fender with those holes ,,it also has 3 holes on each side.. I installed the V fender tip with spears on each side
-
- Member
- Posts: 256
- Joined: Mon Apr 09, 2012 7:38 pm
- Bikes: '02 Fatboy, '47 Knuckle, '52Pan
- Has thanked: 60 times
- Been thanked: 11 times
Re: Front fender
The fender has two sets of holes on the side and three on the top front for a fender light, also has a hole pattern on the rear for wrap-around trim,which is for a wider trim I imagine because the rear trim I just bought is not as wide as the hole pattern, it also has the early fender mounting brackets. Question is does anyone know what year this came off of, Thanks Whitey
You do not have the required permissions to view the files attached to this post.
Re: Front fender
It's a V-Twin fender. Rivets are smaller than stock, and that recessed hole on the fender nose isn't right.
VPH-D
VPH-D