I'm about to paint a repop rear fender for the '50, and want to drill the holes for the mounting screws for the rear stand catch (which will be here next week) before painting.I suspect that the upper screw uses the same hole as the lower screw of the taillight, and have seen the dimensioned pic in the knowledge base, but would like to know the center to center distance to be sure.
Can anyone help?
TIA,
John
Rear stand catch hole spacing
-
- Inactive member
- Member
- Posts: 292
- Joined: Sun Jul 25, 2010 5:18 pm
- Bikes: '50 F model, '76FX/L, '96 96" FXDWG
- Location: SE Florida
- Has thanked: 8 times
- Been thanked: 7 times
- Contact:
-
- Inactive member
- Member
- Posts: 292
- Joined: Sun Jul 25, 2010 5:18 pm
- Bikes: '50 F model, '76FX/L, '96 96" FXDWG
- Location: SE Florida
- Has thanked: 8 times
- Been thanked: 7 times
- Contact:
Re: Rear stand catch hole spacing
Anyone???
Can anyone with a rigid frame pan, with the rear stand installed, measure the distance between the two screws that hold the stand catch to the fender?
Or if you happen to have a fender or rear stand catch handy, could you measure the distance between the holes?
It would be greatly appreciated.
John
Can anyone with a rigid frame pan, with the rear stand installed, measure the distance between the two screws that hold the stand catch to the fender?
Or if you happen to have a fender or rear stand catch handy, could you measure the distance between the holes?
It would be greatly appreciated.
John
-
- Moderator
- Senior Member
- Posts: 3713
- Joined: Mon Dec 01, 2003 11:38 pm
- Bikes: '42 WLA X 2, '55FL, '93 Ultra Classic, '91 Fatboy, '97 883, '03 Rokon Trailbreaker, '83 GPz 750.
- Has thanked: 71 times
- Been thanked: 128 times
Re: Rear stand catch hole spacing
will this help? note, the measurements are to the top of the holes measured from the notch for the hinge.
john
john
You do not have the required permissions to view the files attached to this post.
-
- Inactive member
- Member
- Posts: 292
- Joined: Sun Jul 25, 2010 5:18 pm
- Bikes: '50 F model, '76FX/L, '96 96" FXDWG
- Location: SE Florida
- Has thanked: 8 times
- Been thanked: 7 times
- Contact:
-
- Inactive member
- Member
- Posts: 292
- Joined: Sun Jul 25, 2010 5:18 pm
- Bikes: '50 F model, '76FX/L, '96 96" FXDWG
- Location: SE Florida
- Has thanked: 8 times
- Been thanked: 7 times
- Contact:
Re: Rear stand catch hole spacing
John,
Were those measurements taken from the inside or outside of the fender?
John
Were those measurements taken from the inside or outside of the fender?
John