Kick Stand

Post Reply
heath49036
Member
Posts: 55
Joined: Tue Dec 11, 2012 11:30 pm
Bikes: 1958 Panhead motor in a wishbone frame.
Has thanked: 55 times

Kick Stand

#1

Post by heath49036 »

Does this site have any documentation on how the kickstand is assembled?
Scrap
Senior Member
Posts: 824
Joined: Fri Jul 03, 2009 7:07 am
Bikes: 1957 FL
1980 FLT
74 FXE
2017 road glide
1971 Bonneville
2021 Ural GU
Location: Pawtucket
Has thanked: 248 times
Been thanked: 124 times

Re: Kick Stand

#2

Post by Scrap »

heath49036 wrote:Does this site have any documentation on how the kickstand is assembled?
By he way, if you have trouble installing the spring, assemble it without the stop lever 50099-36. You can then install the spring, lever it into position and install the stop lever.
hplhd
Senior Member
Posts: 638
Joined: Tue Mar 30, 2004 11:48 am
Bikes: 1998 heritage springer
1959 FLH
Location: indiana, usa
Has thanked: 17 times
Been thanked: 19 times

Re: Kick Stand

#3

Post by hplhd »

Scrap wrote:
heath49036 wrote:Does this site have any documentation on how the kickstand is assembled?
By he way, if you have trouble installing the spring, assemble it without the stop lever 50099-36. You can then install the spring, lever it into position and install the stop lever.
i couldn't figure out a way to explain what you just did scrap without confusing the situation. i was afraid the next post would be about not being able to get the spring on. :x
Post Reply

Return to “Frame & Fittings”