Hopefully a stupid question, I installed a belt drive and found that my kickstand now hits the belt. Anyone know of a kickstand that works with this setup?
picture attached
Kickstand fit with BDL Belt drive
-
- Member
- Posts: 56
- Joined: Sat Apr 09, 2011 2:10 am
- Bikes: 1948 Panhead
- Location: US-NY
- Has thanked: 6 times
Kickstand fit with BDL Belt drive
You do not have the required permissions to view the files attached to this post.
-
- Member
- Posts: 93
- Joined: Mon Jun 29, 2009 12:57 am
- Bikes: 52 panhead
- Location: fowlerville,Michigan
- Has thanked: 1 time
- Been thanked: 1 time
Re: Kickstand fit with BDL Belt drive
It looks like you are missing the kickstand stop, that goes just below the nut on the kickstand arm. Here's a picture of the one I use, and you can adjust it to keep it away from the belt. Scott
You do not have the required permissions to view the files attached to this post.
-
- Former member
- Senior Member
- Posts: 3332
- Joined: Sat Jun 26, 2010 1:54 pm
- Bikes: 1958flh 1969sporty,had a knuckle but sold back to original owner
- Location: NEW JERSEY
- Has thanked: 195 times
- Been thanked: 277 times
Re: Kickstand fit with BDL Belt drive
MS-GEEK!--As panbagger said or you can change the shaft to a straight one!-As per my pics in the gallery!--Its the same thing you have ,just no spoon on the end to hit the belt!--(Panbagger would be the cheaper route to go!)--GOOD-LUCK--RICHIE
-
- Member
- Posts: 93
- Joined: Mon Jun 29, 2009 12:57 am
- Bikes: 52 panhead
- Location: fowlerville,Michigan
- Has thanked: 1 time
- Been thanked: 1 time
Re: Kickstand fit with BDL Belt drive
The number under the picture is the J&P part number, and they are between 12 and 13 dollars....... cheap fix. Scott