Mainshaft threads
-
- Member
- Posts: 178
- Joined: Tue Dec 03, 2002 4:26 am
- Bikes: *
- Location: Maine USA
Mainshaft threads
Guys, Does anyone know the size of the threads on the mainshaft retaining nut kicker side? Haggis.
-
- Senior Member
- Posts: 697
- Joined: Sat Jun 05, 2004 5:55 pm
- Bikes: EL, FXE & FLH
- Has thanked: 20 times
- Been thanked: 69 times
Re: Mainshaft threads
Haggis if you are talking about the mainshaft ball bearing nut the thread count is 18
-
- Member
- Posts: 178
- Joined: Tue Dec 03, 2002 4:26 am
- Bikes: *
- Location: Maine USA
Re: Mainshaft threads
Panz4ever,
Yep I think thats the one, right hand side , holds mainshaft to roller bearing, what size is it ?
1 1/8" fine thread? Haggis. My theads got a little beat up on the shaft , going to see if I can chase them with a die while it;s still in the case...should be fun....just want to be certain about the size!!! Haggis.
Yep I think thats the one, right hand side , holds mainshaft to roller bearing, what size is it ?
1 1/8" fine thread? Haggis. My theads got a little beat up on the shaft , going to see if I can chase them with a die while it;s still in the case...should be fun....just want to be certain about the size!!! Haggis.
-
- Senior Member
- Posts: 6937
- Joined: Sun Feb 10, 2002 2:30 am
- Bikes: -
- Location: Central Illinois
- Has thanked: 112 times
- Been thanked: 310 times
Re: Mainshaft threads
The mainshaft is as hard as the hubs o' hell, so you will probably chip a very expensive die. Even if it wasn't an interrupted thread.
(Meaning a slot or two cut through the threads for a lockwasher, not meaning how I barged in on this discussion.)
...Cotten
(Meaning a slot or two cut through the threads for a lockwasher, not meaning how I barged in on this discussion.)
...Cotten
-
- Member
- Posts: 178
- Joined: Tue Dec 03, 2002 4:26 am
- Bikes: *
- Location: Maine USA
Re: Mainshaft threads
Cotten,
"Threadus interuptus"....
The very first thread on the shaft got a little rounded when the old nut spun off under power.
Just need to clean it up a little, dont want to hazard crossthreading the new one on.
Is it worth the try to chase them, still trying to picture what sort of contraption I 'll have to construct to hold the die for use in that confined space. Haggis.
"Threadus interuptus"....
The very first thread on the shaft got a little rounded when the old nut spun off under power.
Just need to clean it up a little, dont want to hazard crossthreading the new one on.
Is it worth the try to chase them, still trying to picture what sort of contraption I 'll have to construct to hold the die for use in that confined space. Haggis.